BVEStation Station Generator Script v1.0
Tired of memorizing the parameters that go into the station command? Use this little script to help you write out your station lines perfect for all route developers.
Module Enter Values | Usage
Station Name: The name of the station obviously
Arrival Time: (hours.minutesseconds)Example: 07.5830 (or 7:58 and 30 seconds)
Departure Time: (hours.minutesseconds)Example: 07.5930 (or 7:59 and 30 seconds)
Pass Alarm: Unknown (Please fill this in)
Doors Open: On the left or the right (-1 = left) (1 = right) (0 = No doors open)
Signal After Station: Use if there's a signal directly after the station (1 = red) (0 = green)
Safety: Select the type of safety system being used (ATS, ATC, etc)
Arrival Sound: Filename of the sound file played on the arrival of the train.
Time Wait: The minimum amount of time the train waits in the station. In Seconds.
Load: Passenger Load (0-250) People might get stuck with a value over 100
Departing Sound: Filename of the sound file played on the departure of the train.
Timetable Index: Specifies the timetable that is displayed

The gray color represents parameters used for the RW station format.

Copyright © 2007-2010 BVEStation All Rights Reserved. | Site Best viewed in 1024 x 768 or higher BVEStation is not owned by or affiliated with any transit agency. Any references or information that is related to specific transit agencies are property, and copyright by them, BVEStation does not endorse illegal activity and takes no responsibility of actions commited by others or of BVEStation members.